HealthyPi v3 HAT Kit for Raspberry Pi (HAT Kit only)

$245.00

HealthyPi is a fully open source, one-of-a-kind vital signs monitor based on a Raspberry Pi as the main computer. This HAT add-on board sits atop the Raspberry Pi 3’s 4o-pin expansion header and turns it into a complete vital sign monitor

Volume discounts

Quantity Discount You Save
10 10% Up to $245.00
100 15% Up to $3,675.00
Quantity

HealthyPi is a fully open source, one-of-a-kind vital signs monitor based on a Raspberry Pi as the main computer. This HAT add-on board sits atop the Raspberry Pi 3’s 4o-pin expansion header and turns it into a complete vital sign monitor

After running a successful Crowd-Supply campaign <cs-link> to get this off the ground, this is now available directly from ProtoCentral India, ProtoCentral USA and also from Crowd Supply.  

Available as a HAT add-on board for Raspberry Pi or a complete kit including the Raspberry Pi along with a microSD card with all the software pre-installed. 

Features and Specifications

  • Parameters monitored:
  • o ECG - single lead with a driven right-leg (DRL) electrodes
  • o Respiration – using impedance pneumography with the same leads used for ECG
  • o Photoplethysmogram (PPG) and SpO2: done with a Nellcor-style finger clip sensor probe
  • o Temperature: digital skin temperature sensor with 0.1 C accuracy
  • Microchip/Atmel ATSAMD21 microcontroller with Arduino bootloader for Arduino M0/Zero compatibility. 
  • USB-CDC interface: Can also work in standalone mode without a Raspberry Pi
  • TI ADS1292R 24-bit analog-frontend chip for ECG and respiration
  • TI AFE4400 pulse-oximetry front-end chip for SpO2
  • Maxim MAX30205 digital temperature sensor
  • Dimensions (board only): 65 mm x 56.5 mm x 6 mm

What’s included:

HealthyPi Basic HAT-only Kit

  • HealthyPi v3 PCB
  • Three-electrode cable with “button” connectors on one end and stereo connector on the other end
  • Finger-clip Spo2 probe with “Nellcor-compatible” DB9 connector
  • Cable-mounted digital skin temperature sensor with stainless steel contacts.
  • A sheet of 20 Single-use disposable ECG electrodes (Covidien Medi-Trace)
  • HAT mounting kit with headers and screws for stacking up the board with a Raspberry Pi

Documentation

 

Important Warning: Although this has all the features of a medical grade patient monitoring system, this does NOT have any certifications (FDA/CE/IEC) and is NOT approved for MEDICAL or diagnostic use. It is your responsibility to ensure your safety when using the device. Never power the device from a non-isolated power source.

PC-HTH-0012

No customer reviews for the moment.

12 other products in the same category